Exhaust Tip 4 Inch Inlet Universal Bolt on Stainless Steel Diesel Exhaust Tailpipe Tip Bolt/Clamp On Design

DESCRIPTION

The end of the final length of exhaust pipe where it vents to open air, generally the only visible part of the exhaust system part on a vehicle, often ends with just a straight or angled cut, but may include a fancy tip. The tip is sometimes chromed. It is often of larger pipe than the rest of the exhaust system. This produces a final reduction in pressure and is sometimes used to enhance the appearance of the car.

FITMENT

Universal fit 4 Inch Inlet, Please Measure Your Pipe Diameter Before Purchase.

The Compatible Just For Reference, Pls Measure Your Pipe's Dimension to Make Sure It Will Fit Before Purchasing

Professional installation would be highly recommended

FEATURES

• Nice Looking

Made from stainless steel and Stainless Steel Polish to provide a sleek look to your car exhaust.

• Tailpipe Protecting

Protects your exhaust pipe from sunlight and rain to prevent rusting and deformation.

• Easy to Install

There is no need to replace any parts, No weld is needed. No drill is needed.

• Bolt-on design

Bolt-on design easily fastens to the exhaust pipe after tightening screws.

• Note:

Please measure the outlet diameter of your exhaust pipe prior to purchasing.
Bolt-on design easily fastens to the exhaust pipe after tightening screws.

INSTALLATION

Step 1: Clean the surface of your tailpipe. 

• Clean the dirt and sand on your tailpipe with penetrating oil and a shop rag.
• (Make sure your tailpipe is at room temperature, and do not clean the surface of the tailpipe after the car just went out).

Step 2: Slide the exhaust tip into your tailpipe. 

• Try to slide the exhaust tip into the tailpipe. You may encounter some resistance, so, if necessary, use automotive grease to lubricate the pieces.
• Cover the end of the exhaust tip with a towel and tap it into a place with a rubber mallet. 

Step 3: Fasten/weld the exhaust tip.

• Tighten screws and clamps to secure the exhaust tips. Should you worry that it is not tight enough, you can weld a joint between the edges of the tailpipe and the exhaust tip.
• Then, The Installation Is Complete.

SPECIFICATION

California Residents: Prop 65 Warning

WARNING:Cancer and Reproductive Harm

Visit:www.p65warnings.ca.gov

- Fit for most vehicles with 4 inch outside diameter pipe
- Ultra lightweight stainless steel
- Rolled edge design
- Easy to install